Loading ...
Loading ...
Loading ...
TO ASSEMBLE GRASS CATCHER
1.Put grass catcher frame into grass bag
with rigidpart of bag on the bottom.
Make sure the frame handle Is outside
ofthe bag top.
2. Slip vinyl bindings over frame.
NOTE: If vinylbindingsare too stiff, hold
them in warm water for a few minutes. If
bag getswet, let it dry before using.
ACAUTION: Do not runyour lawn mower
without clippingdeflector or approved
grass catcher in place. Never attempt to
operate the lawn mower with the rear
door removed or prepped open.
Catcher
fram_
handle
_' bindings
Frame
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may resultin personal injury.Ifyou
believe that the engine is runningtoo fast
or too slow,take your lawn mower to a
Sears or other qualified service center for
repair and adjustment.
CARBURETOR
Your carburetor has a son-adjustable
fixed mainjet for mixture control. If your
engine does not operate propedy due to
suspected carburetor problems, take your
lawn mower to a Sears or other qualified
service center for repair and/or adjust-
ment.
IMPORTANT: Never tamper with the
engine governor, which isfactory set for
proper engine speed. Overspeeding the
engine above the factory high speed
setting can be dangerous. If you think the
engine-governed high speed needs
adjusting, contacta Sears or other
qualified service center, which has proper
equipment and expedenoe to make any
necessary adjustments.
immediately prepare your lawn mower for
storage at the end ofthe season or Ifthe
unitwill not be used for 30 days or more.
LAWN MOWER
When lawn mower isto be stored for a
period of time, clean it thoroughly,remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
1. Clean entire lawn mower (See
"CLEANING" in the Maintenance
section of this manual).
2. Lubricate as shown in the Mainte-
nance section of this manual.
3. Be sure that all nuts, bolts,screws,
and pins are securely fastened.
Inspect moving partsfor damage,
breakage and wear. Replace ff
necessary.
4. Touch up all rusted or chipped paint
surfaces; sand lightlybefore painting.
15
Loading ...
Loading ...
Loading ...