Loading ...
Loading ...
Loading ...
A,CAUTION: Before performing any
service or adjustments:
1. Release control bar and stop engine.
2. Make sure the blade and all moving
parts have completely stopped.
3. Disconnect spark plug wire from spark
plugand place where it cannot come
in contact with plug.
LAWN MOWER
TO ADJUST CU111NG HEIGHT
See "TOADJUST CU'I-rlNG HEIGHT" in
the Operation section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your mower, is provided to
minimize the possibility that objects will
be thrown out ofthe rear of the mower
intothe operator mowing position. If the
deflector becomes damaged, it should be
replaced.
TO REMOVE/REPLACE DRIVE BELT
1. Remove ddve cover. Remove belt
from gearcase pulley by pushing
down on pulley and rolling belt off it.
2. Turn lawn mower on its side with air
filter and carburetor up.
3. Remove blade.
4. Remove debds shield.
5. Remove belt from engine pulley on
crankshaft.
6. Install new bell by reversing above
steps.
7. Always use factory approved bell to
assure fit and long life.
TO ADJUST HANDLE
The upper handle may be adjusted to
four (4) different height positions.
1. Loosen both handle knobs only
enough to allow the upper handle to
pivot to the desired adjustment
position.
2. -tighten both handle knobs securely.
Handle
Knob
Handle
Knob
Drive
cover
Push
14
Loading ...
Loading ...
Loading ...