Loading ...
Loading ...
Loading ...
ADJUSTING THE TABLE SQUARE
TO HEAD
NOTE: The comb _t_onsauare must be "true." See
'Unpacking and Checking Contents" section for
method,
1 Insert a preciston ground steel roe approximately
3" long into chuck and tighten,
2. With table raised to working height and locked on
column, place combination square flat on table be-
side rod
3. If an adjustment is necessary, loosen the set screw
under bevel lock with 3ram Hex L" wrench, then
loosen the table bevel lock with a 15/16" wrench.
_These adjLJstments are located under the tabie_
4. Align the table square to the roa by rotat=ng the
table until the square and rod are in line.
5 Retighten table bevel lock.
6. Retighten set screw,
LOCK
TABLE
/
BEVEL SCALE
NOTE: The bevel scale nas been included to provide
a quick method for bevehng the table to approx_ma[e
angles, If precise accuracy _snecessary, a square, or
other preciston measuring tool should be used to 0ost-
lion the table,
1 To use the bevel scale do the following:
a. Loosen set screw and table bevel lock (see step
3 above),
b_ Move table so desired angle on bevel scale is
straight across from zero line on table support
c. Retighten table bevel lock and set screw.
POINTER
\
SCALE
TABLE
/
16
Loading ...
Loading ...
Loading ...