Loading ...
Loading ...
Loading ...
assembgy
WARNING :FOR YOUR OWN SAFETY, NEVER CON"
NECT PLUG TO POWER SOURCE OUTLET UNTIL
ALL ASSEMBLY STEPS ARE COMPLETED.
TOOLS NEEDED
15/16" BOX END
WRENCH
MEDIUM
SCREWDRIVER
COMBINATION I[(_(.._
SQUARE [L_
8-INCH ADJUSTABLE
WRENCH
FRAMING SQUARE MUST BE TRUE.
Check its accuracy as Illustrated belowo
DRAW LIGHT STRAIGHT EDGE OF
LiNE ON BOARD BOARD 3/4" THICK--
SHOULD BE NO GAP OR OVERLAP WHEN
SQUARE IS FLIPPED OVER iN DOTTED POSiTiON
ASSEMBLY OF COLUMN AND TABLE
HARDWARE
1, Positionbase on floor. Remove protective covering
and discard.
2. Remove protective sleeve from column tube and
discard. Place column assembly on base. one align
holes in column support with holes in base.
3. Locate (4) four 10turn Dia. x 40mrn long bolts (see
illustration) in loose parts bag.
4. Install a bolt in each hole through column support
and base and tighten with aojustable wrench.
COLUMN
10mm DIA x 40ram LONG BOLTS
_'_BASE
.
6.
7.
m__
Locate table crank and support lock in loose arts COLLIMN"_I !
bag P J!P
Install support lock from left side into table support _ _ ._'-_'F__J._L
and tighten by hand _-."3_ ..-"/f
I ' '" " _'_
nstal, table crank assembly and t,ghten set screw "_ 1 /" "/_
witha 3mmHEX"L:'wrench. TJr_y (' _fr "-_'_,.._..,.._ \_L,.,qi'
TABLE
SUPPORT
TABLE
CRANK
COLUMN
8. Position column collar over rack and tignteP set COLLAR
screw in collar, using 3mm HEX "L" wrench.
supplied in loose parts bag, Collar should not be
angled on the column. Only tighten set screw
enough to keep collar in place: rack should still COLUMN
slide freely in collar.
CAUTION: To avoid column or collar damage,
do not overtlghten set screw.
HANDLE
10
Loading ...
Loading ...
Loading ...