Loading ...
Loading ...
Loading ...
MOUNTING MOTOR
1. Locate four (4) 8turn Dig × 20mrn long hex head
bolts, eight (8) flat washers, and four (4) nex nuts
among loose parts.
2. Install hex head bolls through motor bracket on
head,
3. Place motor in position so motor base slots hne up
with motor bracket slots. Install flat washers ane
inex nuts as illustrated (Do not tighten1
4. Motor shaft should be as close as 3ossible to center
of round opening _n belt guard
NUT
8mm DIA x 20mrn LONG BOLT HEX
S J ROUND OPENING
IN BELT GUARD
_FLAT WASHER
HEX HEAD
BOLTS
iNSTALLING MOTOR PULLEY
Find the motor pulley m _oose carts oag.
2. Slide pulley onto motor shaft Line UDthe flat sur-
face on the motor shaft w_th the setscrew _npulley
3 Make sure the pulley goes not rest on the lower
guara
4 Tighten theset screwus=ng a3mmHex "Lwrench
STRAIGHT EDGE
MOTOR BRACKET
MOTOR
BASE
/
HEX
NUT
1
f
FLAT
WASHER
MOTOR
PULLEY
SET SCREW
FLAT
SURFACE
INSTALLING AND TENSIONING BELT
WARNING: TO AVOID INJURY DUE TO ACCIDEN- ,_--_
TAL STARTING ALWAYS TURN DRILL PRESS OFF
/i
AND REMOVE SWITCH KEY BEFORE MAKING
BELT ADJUSTMENTS.
1 Place a stratght edge such as a piece of wood,
metal, or framinc sc uare across the top of pulleys. _
2. Move the motor uoward until the owteys are in line.
Tighten the motor mount nuts using an adjustable
wrench.
NOTE: To avo,a rattles or other norse motor frame
must not toucD lower belt guard
3. Release Belt Tension Lock handles located on
each side of Drill Press head oy [urn_ng them
counterclockwise.
/
/
\ _LO0W/E_R BELT
TENSION
BELT LOCK
GLARD HANDLE
I,=,
®
"_MOTOR
IMOUNT
NUTS
MOTOR
4. Loosen Belt Tension handle by turning clockwise.
BELT
HANDLE
12
Loading ...
Loading ...
Loading ...