Loading ...
Loading ...
Loading ...
16
Installation KIT
Sliding door installation
Push the appliance into the cabinet's compartment
with care (Fig. 5) until you reach stop strip “A”.
You will find the material required for the
installation inside the appliance.
Fig. 5
Open the appliance's door and push in the opposite
direction to the hinge (Fig. 6). Fasten the appliance
with 4 screws, 2 screws on the upper faceplate and
2 on the side corner brace opposite the central
hinge.
Fig. 6
Place runner “A” as per the indications found (Fig.
7) on the inside of the cabinet's door and mark the
place where the screws should be inserted. Bore
holes for the screws. Fasten the runner.
Fig. 7
Open the door of the appliance and of the cabinet
at 90°. Place corner brace “B” (Fig. 8) against the
runner “A”. Ensure that the cabinet's door adheres
well to the appliance's door and mark where the
middle openings are, as shown in the figure (Fig. 8).
Remove corner brace “B” and bore holes for the
screws with a 2 mm Ø drill bit. Place the corner
brace against the runner again and fasten it with the
screws provided.
Fig. 8
If you need to adjust the cabinet's door, use the
lengthwise slot opening in corner brace “B” (Fig.
9).
Fig. 9
Depending on the model, press the cover “D”
provided on corner brace “B”.
Fig. 10
The freezer compartment door is installed with 1
swing door hinge, while the refrigerator's door
requires 2 hinges of this same type.
x 4
x 1
x 27 x 2
x 4 x 4
Loading ...
Loading ...
Loading ...