Loading ...
Loading ...
Loading ...
NOTE:Referencesto rightorleft sideof the snowthrowerare
determinedfromthe operatingpositionlookingforwardto the front of
the machine.
REMOVING FROM CRATE
1. Removescrewsfrom the bottomof thecrate securingthesides,
andendsof the shippingcrate.
2. Lift off the topoff of the crateandsetoutof thewayof the
assemblyarea.
3. Removeand discard plasticbag thatcoversunit.
4. Removeany looseparts includedwith unit (e.g.,Operator's
Manual,etc.).
5. Pushdownonthe lowerhandleandpullunit backout of crate.
6. Makecertainthe crate has beencompletelyemptiedbefore
discardingit.
ASSEMBLY
1. Makecertainthe springsat the lowerend of the augeranddrive
cablesaresecurelyhookedintotheir respectiveactuator
bracketsbeforepivotingthe handle upward.Referto Fig. 10.
a. Placethe speedselectorshiftleverin the F6 position.
b. Cut the cabletie securingthe two piecechute crank to the
lowerhandle.Thecable tie is usedfor shippingpurposes.
c. Removethe upperwingknobandcarriageboltfromeach
sideof the lowerhandle.Pulluponupperhandleas shown
in Fig. 1.Align upper handlewith the lowerhandle.Again,
makecertainthe springsat the lowerendof the augerand
drivecablesaresecurelyhookedintotheir respective
actuatorbrackets.Also,removeany rubberbandssecuring
thecablesto thewing nuts.
\
f
Tightenthe twowingknobsalreadyinstalledinthe upper
holesto firmly securethe upperhandleandsupporttubes.
See Fig.2.
!
{
/
/
Figure2
NOTE: Ifthe full rangeof speeds(forwardand reverse)can not be
achieved,referto the "MakingAdjustments"section.
Chute Directional Control
1. Removethe hairpinclip fromthe spiralcontrolas showninA
of Fig.3.
2. Insertthe chutedirectionalcontrolrod into thefitting on the spiral
controlas seenin B of Fig.3.
3. Securewith the hairpinclip previouslyremoved.See Fig.3.
2.
a.
Figure1
Securethe supportbracket,upperhandleand lowerhandle
withthetwo wingknobs andcarriageboltsremovedearlier.
SeeFig.2.
Figure3
8
Loading ...
Loading ...
Loading ...