Loading ...
Loading ...
Loading ...
12 CONTROL PANEL / CARE & MAINTENENCE
CONTROL PANEL CARE & MAINTENENCE
• Best results are obtained by using a low speed for
normal conditions and a high speed when odours are
more concentrated.
• Turn the hood on for a few minutes before you start
cooking.
• The hood should be left on for a minimum of 5
minutes after cooking or until all odours have
dispersed.
• The control switches are located on the front panel of
the unit. See Fig. 16 below.
A. Filter
• This is the indicator/switch to show when the filter
needs to be cleaned.
• Once the filters are cleaned the ‘Filter’ alert can be
deactivated with a single touch.
B.
Timer
Using the Timer
• At the end of cooking, if the timer is switched on, the
rangehood will continue to run for an additional 5 to
15 minutes, depending on the selected fan speed.
• The fan speed is reduced in 5 minute increments until
the rangehood turns it self OFF.
• If the fan speed is set on high, it will run for 5 minutes
then reduce to medium for 5 minutes, then reduce to
low for 5 minutes before finally turning it self OFF.
• This should ensure the removal of any odours that
remain after cooking.
C.
Lights
To switch Lights On and OFF
• Touch the ‘light’ symbol to turn the lights ON.
• Touch the ‘light’ symbol again to turn the lights OFF.
D.
Power on/off
E.
Fan speed 1
Light frying/boiling
F.
Fan speed 2
Frying/wok cooking/heavy boiling
G.
Fan speed 3
Grilling, intensive frying and wok cooking
NOTE. This product is fitted with a safety cutout device.
If the cooker hood is installed to close to the cooktop,
flambe cooking, operating the cooktop without cooking
utensils and blocked filters may activate the safety cutout
device. If the hood stops during operation, correct the
faults and allow time for the safety cutout device to reset,
the cooker hood will then function correctly.
WARNING
CAUTION
External surfaces are susceptible to scratches and
abrasions, so please follow the cleaning instructions
to ensure the best possible result is achieved without
damage
Cleaning the hood
• Clean the outside of the hood using a damp cloth and
a solution of water and mild washing up liquid. Clean
stainless steel surfaces using non-abrasive cleaning
products that are specifically for use on stainless
steel. To ensure the best results also use an even
pressure and follow the grain of the stainless steel.
Use of a soft cloth reduces the risk of scratching. If
the cloth is wet ensure that a dry soft cloth is used
to wipe down the surface and apply stainless steel
protector to reduce the risk of any surface rust
appearing.
• Never use corrosive, abrasive or flammable cleaning
products or products containing bleach.
• Never insert pointed objects in the motors protective
grid.
• Only ever clean the switch panel and filter grill using a
damp cloth and mild washing up liquid.
• It is extremely important to clean the unit and change
the filters at the recommended intervals. Failure to do
so will cause grease deposits that could cause a fire.
Removing the metal grease filters
• Push the grease filter and then pull it down and out.
Fig. 16
Loading ...
Loading ...
Loading ...