Loading ...
Loading ...
Loading ...
Aboutcrisper removal
Not all features are on all models.
Crisper Removal
To Remove:
These drawex5 can be remoxed easily b)
lifting up slighfl) while pulling tile drawer
past tile stop location.
When the door cannot be fully opened,
rein ore the dra wet fi_rth est from the door
fixst. Make sure the drawer closest to the
door is fifllv closed. There is a latch at the
front of the center slide rail. Push down on
the latch and slide the center slide rail, to
which the drawer is attached, awa)' fi'om the
dora; Remove tile drawe_:
Aboutthe automatic icemaker.
A newly-installed refrigerator may take 12-24 hours to begin making ice.
Power
Switch Icemaker
Power switch model
i jl
FeelerArm in up post on
the ON down "
position
Feelerarm model
Automatic Icemaker (onsomemodels)
Tile icemaker will produce seven or eight
cubes (depending on model) per cycle--
apl/u)ximatel ) 100-130 cubes in a 24-horn"
period, depending on fl'eezer compartment
telnl)erature , rooin telnl)erature , nulnber
of door ol)enings, and other t/se conditions
There are two tH)es of icemake_: power
switch models and teeler am/models.
If tile reti_igerator is operated heft)re tile
water connection is made to tile icemake_;
set the power switch to 0 (off) or move the
teeler ann to tile STOP (up) position.
When the refl_igerator has been connected
to tile water SUl)ply; set tile power switch to
tile I (on) position or move tile teeler am_ to
tile ON (down) position. On power switch
models, the green light will come on.
You will hear a buzzing so/md each time
tile icemaker fills with water:
The icemaker will fill Mth water when it
cools to approximately IS°F. A newl)'-
installed refrigerator may take 12 to 24
hom_ to begin making ice cubes.
Throw awm tile first tew batches of ice to
allow the water line to clem:
Be sure nothing interferes with tile sweep
of the feeler am/.
\,_l/en tile bin fills to tile level of tile teeler
am/, tile icemaker will stop produdng ice.
It is nomml fin" several cubes to be joined
together
If ice is not used fl'equenfl> old ice cubes
will become cloud> taste stale and shrink.
On power switch models, tile green power
light will blink if ice cubes get stuck in tile
icemaket: To correct this, set tile power
switch to 0 (off) and renlove tile cubes. Set
tile power switch to I (on) to restart tile
icemake_: _Mter tile icemaker has been
turned on again, there will be a delay of
about 45 minutes before tile icemaker
I'eStllIleS ol)eI_ltion.
NOTE: In homes with lower-than-average water
pressure, you may hearthe icemaker cyclemultiple
times when maklbgone batch of ice.
/0
Icemaker Accessory Kit
If your refi_gerator did not come ah'ead_
equipped with an automatic icemakex;
an icemaker accessor_ kit is a_ filable at
extI'a cost.
Check tile back of tile refl_igerator fin.
the specific icemaker kit needed fin.
VO//I" model.
Loading ...
Loading ...
Loading ...