Loading ...
Loading ...
Loading ...
NOTE: Before installing blade
brackets to the motor, please
remove the plastic inserts.
PAGE: 7 / 9
Secure blade brackets to the motor with
motor screws and washers.
Assembly without fan light
Make sure the lead wire of fan light
in switch box is sealed with a wire
connector exactly. Secure the switch box
cover with the switch box screws.
Replace the fan housing inner bulbs
Screw
Plastic Insert
Fig.14
Motor Screw
Blade Bracket
Fig.16Fig.15
Switch Box
Screw
Fig.21
Connect the two terminals respectively
from the motor and the switch box.
Open the inner light plate of worse bulbs
by screw driver.Take off the worse bulb
and install the new one.
Secure the inner light plate back
Switch Box
Screw
Fig.22
F A N C OF A N C O
190104
4-4W Type B11 E12
LED Bulbs
4-4W Type B11 E12
LED Bulbs
(Included)
(Included)
Fig.18
Turn ON the electric circuit at the
main fuse or circuit breaker box.
The slide switch sets the direction
of fan rotation. Select the direction
of fan rotation you need by sliding
the switch.
Push the slide switch left for
"Forward" and right for "Reverse".
Fig.17
Slide Switch
Reverse
Forward
Fig.19
UP / L
DOWN / L
HI
LOW
OFF
MED
Install the battery (9V, included) to the transmitter.
Turn on the electric circuit.
Press "HI" button to
operate
the fan in high speed.
Press "MED" button to
operate
the fan in medium
speed.
Press "LOW" button to
operate
the fan in low speed.
Press "OFF " to turn the fan off.
Press and release the "UP/L" button quickly to turn
on/off the light.
Press and hold the "UP/L" button to adjust the
illumination of light with the dimmer switch.
Press and release the "DOWN/L" button quickly to
turn on/off the the light.
Press and hold the "DOWN/L " button to adjust the
illumination of light with the dimmer switch.
Note:
This remote controller has memory function setting.The fan will operate at the same
speed and the fan light will stay at the same status as the last time the power supply
was turned off.
HI
OFF
U/L
D/L
Install the transmitter wall bracket in
wall by two screws and hang
transmitter in it carefully. (See Fig.20)
Fig.20
Wall Bracket
Transmitter
Screw
MED
HI
OFF
U/L
D/L
LOW
Loading ...
Loading ...