Loading ...
Loading ...
Loading ...
13
Installation Instructions
INSTALATION INSTRUCTIONS
Outside Faucet
(Hard Water)
Soft, Cold Water
Soft, Hot Water
Outside Faucet
(Hard Water)
Water
Heater
Shutoff
Valve
Hard Water Line
Water
Softener
Hard
Water
to
House
Main Shutoff
Valve
Storage Tank
Water
Meter
Reverse Osmosis
System
BLUE Tubing
to Reverse
Osmosis Faucet
Soft Water -
GREEN Tubing
to Reverse
Osmosis System
YELLOW Tubing
to Storage Tank
Reverse Osmosis
Drain - RED
Tubing to Drain
RED
Tubing to
Drain
1/4'' RED Tubing
Floor
Drain
1-1/2”
Air Gap
1-1/2”
Air Gap
1-1/2”
Air Gap
1-1/2”
Air Gap
Sump
Laundry
Tub
Stand pipe
ALTERNATIVE DRAIN INSTALLATION (for a remote location)
INSTALL A DRAIN POINT AND AIR GAP
(for a remote location)
Route the drain tubing to an existing drain in the
house. A floor drain, laundry tub, standpipe, sump,
etc. are suitable drain points. Be sure to provide a
1-1/2” air gap between the end of the hose and the
drain point. This will prevent water from backing
up into the system.
NOTE: Check your local plumbing codes.
To install a remote drain point, complete the
following steps:
1. Locate the 1/4” red tube and determine whether
it is long enough to reach from the Reverse
Osmosis assembly to the drain point.
2. If longer tubing is required, see parts list in back
of manual and replace the red tube with an
adequate length of 1/4” tubing.
3. Cut one end of the drain tube square.
4. Insert this tube all the way into the red collet
fitting on the Reverse Osmosis filter assembly.
See illustration on page 17.
5. Pull on the tubing to be sure it is held firmly in
the fitting.
NOTE: A flow control insert is located inside the
elbow fitting that the drain tube connects
to. Leave this fitting in place.
6. Route the tubing to the drain point and secure at
the end with a bracket (not included). Provide a
1-1/2” air gap between the end of the tube and
the drain.
Loading ...
Loading ...
Loading ...