Kenmore 41771722512 laundry center/combo

User Manual - Page 22

For 41771722512.

PDF File Manual, 24 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Avoid Service Checklist
OCCURRENCE POSSIBLE CAUSE SOLUTION
Excessive wrinkling.
Scratching or chipping of
the drum finish.
Dryer is overloaded.
Items left in dryer too long.
Insufficient sorting of items.
Drying temperature too high.
Foreign objects such as eoins_ pins_ clips or buttons
are inside the dryer. _
Permanently attached items such as belt buckles, zippers
and fasteners may be hitting the inside of the drum. _
Do not overload. See "'Operating Instructions."
Remove items as soon as cycle ends.
See "'Operating Instructions."
Follow fabric care label instructions.
Always remove foreign objects from pockets before laundering.
Remove objects from drum and restart dryer.
Turn items inside out before drying to prevent scratching and damage
to the dryer.
_Drum damage caused by foreign objects or permanently attached items is not covered by the warranty.
Wash load too wet after Washer is overloaded. Do not overload washer. See Washing Procedures.
spin. Load is out of balance. Rearrange load to allow proper spinning.
Drain hose is kinked. Straighten drain hose.
Water does not enter Washer lid is open. Close washer lid. The washer will not operate when the lid is open.
washer or it enters slowly. Water supply is not adequate in area. Check another faucet in the house. Wait until water supply and
pressure increase.
Water supply faucets are not completely open. Fully open hot and cold faucets.
Water is being used elsewhere in the house. Water pressure must be at least 10 psi (69 kPa). Avoid running
water elsewhere while washer is filling.
Water inlet hoses are kinked. Straighten hoses.
Warm or hot water is not Hot water heater is set too low or is a distance Measure hot water temperature at nearby faucet with candy or
hot enough, from washer, meat thermometer. Water temperature should be at least 120°F
(50°C). Adjust water heater as necessary.
Hot water is being used elsewhere in the house. Avoid using hot water elsewhere before or during washer use.
There may not be enough hot water available for proper clean-
ing. if problem persists_ your hot water system may be unable
to support more than 1 use at a time.
Water in washer does not Drain hose is kinked or clogged. Clean and straighten the drain hose.
drain or drains slowly.
Water leaks. Loose fill hose connection at faucet or washer. Check and tighten hose connections, install rubber sealing
washers provided.
House drain pipes are clogged. Unclog drain pipes. Contact plumber if necessary.
incorrect wash and rinse Hot and cold water hoses are connected to wrong Connect hot water hose to hot water faucet and cold water
temperatures, supply faucets, hose to cold water faucet.
Water is entering washer Drain hose standpipe is incorrect height. Standpipe must be a minimum of 33" (83.82 cm) high to pre-
but tub does not fill. vent siphoning. See INSTALLATION INSTRUCTIONS.
Water is present in tub after Lid lock malfunction. Do not bypass lid lock. Call a Sears or other qualified service
wash cycle is complete, dealer.
The drain and spin cycles Lid lock malfunction. Do not bypass lid lock. Call a Sears or other qualified service
did not occur, dealer.
22
Loading ...
Loading ...