Loading ...
Loading ...
Loading ...
Fence Positions
The miter saw has two fence positions, The front fence
position is used for workpieces up to standard 2 x 4 for
cut off and bevel operation, floor and ceiling moldings,
and door casings. The rear fence position is used
for cut off and bevel operation for a standard 2 x 6
workpiece.
Standard 2 x 4 measures 1_,/' x 3_,/'
Standard 2 x 6 measures 1_,5'' x 5_''
The base on either side of the work table has two sets
of holes for locating the fence. To change the fence
position, remove the two fence lock handles. Put the
fence in the other fence position and instali the fence
lock handles.
The rear fence position is designed to slide side to side
when the miter setting is changed Th_s feature lets the
fence move to provide maximum support for the work-
piece If it _s necessary to change the miter cut in the
rear position, first loosen the fence lock handles. Re-
lease the miter lock handle and move it to the desired
miter angle. Tighten the miter lock handle and the fence
lock handles.
CAUTION: Do not try to change the miter position
while the fence is in the rear fence position before
loosening the fence lock handles. You might dam-
age the fence alignment arm.
On/Off Trigger Switch
To prevent the trigger from being accidentally engaged,
a lock-off button is provided, To start the tool, press in
the lock-off button and squeeze the trigger Release
the trigger to stop the miter saw
]
.........
REAR FENCE POSITION
Removing or Installing the Blade
WARNING: To avoid injury from a thrown work-
piece or thrown pieces of blade, do not use a
blade arger or sma er than 10" diameter.
WARNING: To avoid injury from unexpected start-
ing, unplug the saw whenever you are removing
or installing the blade.
1 Unplug the saw from the outlet.
2. Loosen the screw holding the lower guard mounting
plate to the upper guard with phillips screwdriver.
3, Lift the lower guard up and tilt the lower guard assem-
bly back so the arbor screw is exposed
4, Find the arbor lock between the upper guard and
the miter saw handle. Place a _'_" box end wrench
over arbor screw.
5. Press the arbor lock and hold it in firmly while turning
the wrench clockwise. The arbor lock will engage
after some turning of the wrench,
6. Remove the arbor screw, arbor washen outer blade
collar, and the blade
12
UPPER /
BLADE
GUARD
,L
t
ARBOR
SCREW
_"BOX WRENCH
/
:3
_ [
MITER SAW
HANDLE
/
Loading ...
Loading ...
Loading ...