Loading ...
Loading ...
Loading ...
Assembly
Your generator requires some assembly and is ready for use
after it has been properly serviced with the recommended oil
and fuel.
If you haveany problemswith the assembly of your generator,
pleasecall the generator helpline at 1-800-743-4115. If calling
for assistance,pleasehavethe model, revision, and serial
number from the identificationlabel available.SeeGenerator
Controls and Featuresfor identification labellocation.
UnpackGenerator
1. Set the carton on a rigid, fiat surface.
2. Remove everything from carton except generator.
3. Opencarton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install wheel kit.
Shipment Contents
The generator is suppliedwith:
3. insert retaining pin (B) through hole on axle stud.
4. Slide a wheel (C) over axle stud.
NOTICE Besure to install wheel with raised hub inboard.
5. Attach wheel to axle stud with a washer (D), lock
washer (E) and nut (F). Tighten with a 18 mm socket
wrench and 18 mm wrench.
6. Place hub cap (G) into center of wheel and push until it
snaps into place.
7. Repeatsteps 2 through 6 to secure secondwheel.
8. Line up holes in support leg (H) with holes in generator
frame.
• Engineoil bottle
• Operator's manual
• Wheel kit
.......... 9. Attach SU_Q[t leg using 4 capscrews (,!) and 4 hexInstall Wheel Kit
nuts (Ki Tigfi_ with a 10 mm socket wrench and
NOTICE Wheel kit is not intended for over-the-road 8_e 13 m_ w[e_bh.
You will needthe following tools to install thes_ .............. to normal operating position (resting
components: ..............
• 13 mm and 18 mm wrench
• Socket wrench with 10 mm and 18 mm sockets
InstalJthe wheelkit as follows:
1. Tip generator so that engine side is down. ..................................................
2. Slide axle stud (A)through mounting .....
threaded end facing out.
Loading ...
Loading ...
Loading ...