Loading ...
Loading ...
Loading ...
ADJUSTMENT/REPAIR
BELT ADJUSTMENT
Traction Drive Belt
The traction drive belt has constant spring pressure and does
not require an adjustment. If the traction drive belt is slipping,
replace the belt. See "How To Replace The Belts" in the
Maintenance section.
Auger Drive Belt
If your snow blower will not discharge snow, check the control
cable adjustment. If it is correct, then check the condition of
the auger drive belt. If it is damaged or loose, replace it (see
Belt Replacement in this section of the manual).
1. Disconnect spark plug wire.
2. Remove screw from belt cover. Remove belt cover
(see Figure 29).
3. Loosen nut on auger idler pulley and move auger idler
pulley towards belt about 1/8 inch (3 mm) (see
Figure 32).
4. Tighten nut.
5. Have someone engage auger drive clutch. Check ten-
sion on belt (opposite idler pulley). Belt should deflect
about 1/2 inch (12.5 mm) with moderate pressure
Figure 30). Youmay have to move idler pulley more than
once to obtain the correct tension.
6. Reinstall belt cover.
7. Whenever belts are adjusted or replaced, the cables will
need to be adjusted. (See Cable Adjustment in this sec-
tion of the manual).
8. Attach the spark plug wire.
Figure 29
l ,_ Auger
E%ve
Pu,ey
J _ "_ 1/2 inch
idler_" V' _j ..._'_\ Deflection
Pulley / _' /&
Engaged _ f \,_
Pulley
Figure 30
F-031020L 24
Loading ...
Loading ...
Loading ...