Loading ...
Loading ...
Loading ...
8. Make sure the chain tension pin hole (19) on the
guide bar fits correctly with the bolt (16).
19
17
16
9. Install the chain cover.
10. Tighten the chain. Refer to Adjust the chain tension.
11. Tighten the chain cover knob when the chain is
correctly tensioned.
NOTE
If you start the chain saw with a new chain, have a
test for 2-3 minutes. A new chain gets longer after the
first use, examine the tension and tighten the chain if
necessary.
10.2 ADJUST THE CHAIN TENSION
The more you use a chain the longer it becomes. It is
therefore important to adjust the chain regularly to take
up the slack.
Tension the chain so that it can only just be pulled away
from the bar at its centre point.
WARNING
A slack chain may jump off and cause serious or even
fatal injury.
CAUTION
Wear protective gloves if you touch the chain, bar or
areas around the chain.
1. Stop the machine.
2. Loosen the chain cover by turning the chain cover
knob counterclockwise.
NOTE
It is not necessary to remove the chain cover to adjust
the chain tension.
3. Turn the chain tension knob clockwise to increase
the chain tension.
4. Turn the chain tension knob counterclockwise to
decrease the chain tension.
5. When the chain is at the wanted tension, tighten the
chain cover.
NOTE
During normal saw operation, the temperature of
the chain increases. The drive links of a correctly
tensioned warm chain will hang approximately 1/16 in.
(1,58 mm) out of the bar groove.
1/16 in. (1,58 mm)
10.3 SHARPEN THE CUTTERS
Sharpen the cutters if chain does not go into wood
easily.
NOTE
We recommend that a service center, which has
an electric sharpener, perform important sharpening
work.
1. Tensioning chain.
2. Sharpen the cutters corner with a 5/32 in. (4 mm)
diameter round file .
12
English
EN
Loading ...
Loading ...
Loading ...