Loading ...
Loading ...
Loading ...
(317,1)
北米Model "A1490BE-A" EDITED: 2022/ 2/ 15
a road covered with deep snow where
the points of contact between the tires
and road surface are not visible, or for
driving on a muddy road.
. For models with 2 modes: When the
X-MODE is ON, the Vehicle Dynamics
Control system cannot be switched ON
and OFF using the Vehicle Dynamic
Control OFF switch. The Vehicle Dy-
namics Control system is fixed to ON in
“SNOW·DIRT” and OFF in “DEEP
SNOW·MUD”.
. Even if you try to activate the
X-MODE by pressing the X-MODE
switch when the vehicle speed is 12
mph (20 km/h) or more, the X-MODE will
not be activated. At this time, a buzzer
will sound twice.
. If the vehicle speed reaches 25 mph
(40 km/h) or more while the X-MODE is
activated, a buzzer will sound once and
the X-MODE will be deactivated.
. For models with SI-DRIVE, the
SI-DRIVE mode will change to the
Intelligent (I) mode when the X-MODE
is deactivated.
. For models with SI-DRIVE, the
SI-DRIVE mode will not be affected
even if the SI-DRIVE switch is pressed
while the X-MODE is activated. At this
time, the buzzer will sound twice.
. For models with Auto Start Stop
system, the system will be stopped
while the X-MODE is activated.
. While the engine is running, if any of
the following conditions is met, the
X-MODE will be deactivated. In this
case, it is not possible to activate the
X-MODE. Also, for models with
SI-DRIVE, the mode will change to the
Intelligent (I) mode and it will not be
possible to change to the other modes.
– The CHECK ENGINE warning
light/Malfunction indicator light illu-
minates.
– The AT OIL TEMP warning light
flashes.
– The ABS warning light illumi-
nates.
– The Vehicle Dynamics Control
warning light illuminates.
. If there is a possibility that the
engine could overheat because of a
temperature increase of the engine
coolant, it is not possible to activate
the X-MODE. Even while the X-MODE is
activated, the X-MODE will be deacti-
vated when the engine coolant tem-
perature increases. In this case, the
mode will change to the Intelligent (I)
mode (models with SI-DRIVE).
& Hill descent control function
S07BI03
The hill descent control function will be in
standby mode when the X-MODE is
activated and the vehicle speed is less
than approximately 12 mph (20 km/h).
The function will operate when the vehicle
speed is less than approximately 12 mph
(20 km/h) and the accelerator ratio is less
than approximately 10%.
The function will turn off when the vehicle
speed is more than approximately 12 mph
(20 km/h) and the accelerator pedal is
depressed.
CAUTION
The braking power of the hill des-
cent control function may not be
sufficient when strong braking
power is needed (e.g., when towing
a trailer).
NOTE
. Even while the hill descent control
function is operating, you can vary the
vehicle speed by using the brake pedal
or accelerator pedal.
. During braking by the hill descent
control function, the stop lights will
illuminate.
– CONTINUED –
Starting and operating/X-MODE
7-45
7
Loading ...
Loading ...
Loading ...