Loading ...
Loading ...
Loading ...
CONNECTING THE iNLET HOSE
The dryer must be connected to the cold water tap
using the new water supply hose. Do not use old hoses,
NOTE:
• Water supply pressure must be between 21.8 PSI and
116 PSi (]50_800 kPa).
° Do not strip or cross=thread when connecting inlet hose
to the valve,
" If the wafer supply pressure is more than 116 PSI (800
kPa), a pressure reducing valve should be installed.
• Periodically check the condition of the hose and
replace the hose if necessary.
• Replace inlet hoses after 5 years of use to reduce the
risk of hose failure.
• Record hose insta{lation or replacement dotes on the
hoses for future reference.
lo Check the rubber seal in the inlet hose. Two rubber
seals are supplied with each inlet hose. They are used
for preventing water leaks. Make sure the connection
to the cold water tap is tight.
RubbzoI
Y connector
2. Check the installation type.
I
i_ y" hose
'_Y connector
__ Long
nose
W_TH WASHER WITHOUT WASHER
Conned all wafer supply hoses tightly by hand and
then tlghfen another 2/3 turn wifh pllers.
WITH WASHER: When connecting the dryer to the same
faucet as a washer.
a, Shut off _'he cold water fop and remove the washer
hose.
b. Connect the short hose to the Y-connector.
c. Connect the other end of the short hose to the cold
wafer fa,acet.
d. Connect the long dryer hose to one side of the Y-connector
and connect the washer hose to the other side,
WITHOUT WASHER: If the dryer does not share the
co{d water tap with a washer.
a. Connect the straight end of the long hose to the cold
water faucet.
NOTE:
• Before connecting the water line to the dryer t flush
several gallons of wafer into a drain or bucket. This
will help prevent foreign particles such as sand and
scale from cloggong the dryer inlet vane.
• Do not overfighten. Damage to the coupling can
result.
.
Connect the hose to the dryer.
Connect the water supply hose to the dryer inlet
valve tightly by hand and then tighten another 2/3
turn with pliers. Make sure that there are no kinks in
the hoses and that they are not crushed.
4. Turn on the cold water faucet.
5. Check for leaks at the Y-connector (if used) and all
hoses.
I I
NOTE:
" If any leaks are found_ shut off the water faucet,
remove the hose and check the condition of the hose
washer.
16
Loading ...
Loading ...
Loading ...