Loading ...
Loading ...
Loading ...
Idle
Speed
The idle speed has been pre-set at the factory and should rarely
require readjustment.
A.WARNING:
Improper adjustment
of
idle speed will damage your engine and
void your warranty
Adjustment
Except as described
in
this Manual, there
is
no additional
maintenance or adjustment required for your engine.
Improper adjustments or tampering can damage your engine and
your equipment and will void your warranty.
A.WARNING:
Tampering with the factory set governor will damage your
engine and void your warranty.
TROUBLE
ANALYSIS
AND
TROUBLESHOOTING
Symptom
Possible
Solutions
Cause
Generating set
Turn the switch to the
"ON"
switch
is
position.
"OFF".
There
is
no fuel.
Fill tank per instructions
in
this
manual.
Check oil level. This engine
is
Inadequate
equipped with a low oil sensor.
The engine cannot be started
engine oil.
unless the oil level
is
above the
prescribed lower limit.
Remove the spark plug cap.
Engine cannot
Clean any dirt from around the
be started.
plug base, and then remove the
spark plug. Install the spark plug
in
the plug cap. Turn the engine
switch
"ON". Grounding the
electrode to any engine ground,
There's no
pull the recoil starter to see if
ignition. sparks jump across the gap. If
there
is
no spark, replace the
plug.
STORAGE
AND
TRANSPORTATION
Storage
The generator should be started at least once every
two
weeks
and allowed to
run
for at least 20 minutes. Follow the
instructions below for longer term storage if the generating set will
be out
of
service for 2 months or more.
A.DANGER:
FIRE OR EXPLOSION
Gasoline
is
highly flammable and extremely explosive.
Empty the fuel tank before storing
or
transporting the generator.
1 . Allow the generator to cool completely before storage.
2. Clean the generator according
to
the instructions
in
the
Maintenance section.
3.
Drain
all
fuel completely from the fuel hose and carburetor
to prevent gum from forming.
4.
Turn off the fuel supply at the fuel valve.
5.
Change the oil.
6.
Reattach the spark plug.
7.
Remove the spark plug and pour about 15ml
of
oil into the
cylinder. Crank the engine slowly
to
distribute the oil and
lubricate the cylinder.
8.
Store the unit
in
a clean, dry area out
of
direct sunlight.
Transportation
To
prevent fuel spillage when transporting
or
during temporary
storage, the generating set should be secured upright
in
its
normal operating position, with the engine switch
OFF.
The fuel
valve lever should be turned
OFF.
A.WARNING:
When transporting:
DO
NOT overfill the tank.
DO
NOT operate the generator while it is on vehicle. Take the
generator off the vehicle and use it
in
a well-ventilated place.
Avoid a place exposed to direct sunlight when putting the
generator on a vehicle. If the generator is left
in
an
enclosed
vehicle for many hours, high temperature inside the vehicle
could cause fuel to vaporize resulting
in
a possible explosion.
DO
NOT drive on a rough road for
an
extended period with the
generator on board. If you must transport the generator
on
a
rough road, drain the fuel from the generator beforehand.
Reinstall the plug and start engine
according
to
instructions
in
this
manual.
Consult Customer Service if
necessarv.
There's no
Reset circuit breakers.
ignition.
Check cord set or extension
Generator
Inadequate cords capabilities
in
section
has no output.
cord set or Controls; Cable Size
in
this
extension manual
cords. Consult Customer Service if
necessarv.
16-ENG
Loading ...
Loading ...
Loading ...