Loading ...
Loading ...
Loading ...
6.
After the engine is running, move the choke valve to "OPEN"
position.
CLOSE
OPEN
A WARNING:
Connect the output terminal
of
the generating set with the
electrical equipment. Don't start or stop the engine when the
electrical equipment is
in
"ON" status.
Connect
to
electrical
devices
Inspect power cord for damage before using. There is a hazard
of
electric shock from crushing, cutting
or
heat damage.
ADANGER:
Electric
Shock
To
reduce the risk
of
electrical shock,
DO
NOT use electrical
cords that are worn, frayed, bare or otherwise damaged.
DO
NOT touch bare wires
of
receptacles.
DO
NOT handle generating set or electrical cords while standing
in
water, while barefoot, while hand
or
feet are wet.
• Allow the engine
to
stabilize and warm up for a few minutes
after starting.
• Make sure the electrical devices
in
"OFF"
position and the
load current is not higher than the maximum capacity current
of
single socket.
A CAUTION:
If the current
of
single load is higher than the maximum capacity
current
of
single socket, please disconnect the load.
A CAUTION:
If connected devices overheat, turn them off and disconnect
them from generator.
Bearing
capacity
A WARNING:
DO NOT overload the generating set.
Exceeding the capacity
of
generator can damage the generator
and/or electrical devices connected to it.
•
You
must make sure your generator can supply enough
rated (running) and surge (starting) watts for the electrical
devices you will power at the same time. Follow these simple
steps
to
calculate the running and starting watts necessary for
your purposes.
1.
Select the electrical devices you will power at the same time.
2.
The amount
of
power you need
to
run
all
the devices
is
the
total rated (running) watts
of
these items.
3.
Identify how may surge (starting) watts you will need. Surge
wattage is the short burst
of
power needed to start electric
motor-driven tools
or
appliances such as a circular saw or
refrigerator.
• Because not all motors start at the same time, total surge watts
can be estimated by adding only the electrical device(s) with
the highest additional surge watts to the total rated watts from
step
2.
A WARNING:
You
must isolate the generator from electric utility by opening
the electrical system's main circuit breaker or main switch if the
generator is used for backup power. Failure
to
isolated the
generator from the power utility may result
in
injury or death to
electric utility workers and damage
to
the generator due to
backfeed
of
electrical energy.
A WARNING:
Storage batteries give off explosive hydrogen gas while
recharging.
An
explosive mixture will remain around then battery
for a long time after it has been charged. The slightest spark can
ignite the hydrogen and cause
an
explosion, resulting
in
blindness
or
other serious injury.
A WARNING:
DO
NOT allow smoking, open flame, sparks or any other source
of
heat around a battery. Wear protective goggles, rubber apron
and rubber gloves when working around a battery.
Battery electrolyte fluid
is
an
extremely caustic sulfuric acid
solution that can cause severe burns. If spill occurs flush area
with clear water immediately.
12-ENG
Loading ...
Loading ...
Loading ...