Loading ...
Loading ...
Loading ...
Oil level
gauge
4.
Fully tighten the dipstick.
5.
Properly dispose of any used oil at an approved waste
management facility.
Change
Oil
A CAUTION:
Change oil when the engine
is
warm from operation.
1 . Place the engine on a level surface.
2.
Clean area around dipstick and drain plug.
3.
Remove oil dipstick.
4.
Remove the oil drain plug and allow the oil to drain completely.
5.
Reinstall and fully tighten the drain plug.
6.
Add recommended oil to the upper limit (see add OIL
instruction above). Reinstall and fully tighten the dipstick.
7.
Dispose of used oil at
an
approved waste management facility.
A WARNING:
The engine
is
not filled with oil at the factory. Any operation
before it has been properly filled with the recommended type
and amount
of
oil may result
in
engine damage and void
your warranty.
Air
Filter
1.
Loosen the filter fix clamp and remove the cover
of
the air filter.
0 Filter fix clamp
8 Foam filter element
2.
Remove the foam filter element.
8 Air filter cover
0 Air filter body
3.
Wash
in
liquid detergent and warm water.
4.
Squeeze thoroughly dry
in
a clean cloth.
5.
Saturate
in
clean engine oil.
6.
Squeeze
in
a clean, absorbent cloth to remove all excess oil.
7.
Place the filter
in
the assembly.
8.
Fasten the air filter cover with the fix clamp, and then mounting
it back
to
the air filter body.
A WARNING:
DO
NOT
run
the engine without the air filter. Serious damage to
the engine can result without the air filter.
Spark
Plug
1.
Clean any dirt from the spark plug cap and spark plug base.
2.
Remove the spark plug cap.
3.
Use a socket wrench to loosen and remove the spark plug.
4.
Inspect the spark plug and spark plug washer. If they are
damaged or worn, replace with new one. Clean the spark plug
with a wire brush if it can be reused.
5.
Check spark plug gap. Carefully bend side electrode to adjust
the gap if necessary.
Spark plug gap: 0.6mm - 0.8mm
0.6mm - 0.8mm
=::~:==fill
Check
spark
plug
gap
6.
Carefully thread the plug into the engine by hand.
7.
After the spark plug is seated, use spark plug wrench to tighten
the plug.
Spark Plug Torque: 15-20N.m
8.
Attach the spark plug cap to the plug.
A WARNING:
Only use recommended spark plug or equivalent.
DO
NOT use
spark plugs that have improper heat range.
Spark
Arrester
(Applicable
types)
1.
Allow the engine to cool completely before servicing the
spark arrester.
2.
Remove the two screws holding the cover plate which retains
the end
of
the spark arrester to the muffler.
3.
Remove the spark arrester screen.
4.
Carefully remove the carbon deposits from the spark arrester
screen with a wire brush.
5.
Replace the spark arrester if it
is
damaged.
6.
Reinstall the spark arrester
in
the muffler and attach with the
two
screws.
Clean
carbon
deposits
15-ENG
Loading ...
Loading ...
Loading ...