Loading ...
Loading ...
Loading ...
Door Removal instructions (Continued)
NOTE
You wiii be pulling approximately five feet of water tube
from the back of the refrigerator.
4. Unscrew the three lower hinge screws and hinge if
necessary,
To reinstall the right door, reverse the above steps.
Lower Hinge Removal
Once both doors are in place, ensure they are aligned with
each other and level (Please see the "Installation" section for
more details), and replace the top hinge cover.
_ CAUTION
Be sure doors are set aside in a secure position where they
cannot fall and cause personal injury, or damage to the
doors or handles. When relnserfing the water tube and
replacing the top hinge cover, use care to be sure you do
not kink the tube.
Removing Freezer Drawer
1. Open freezer drawer.
2. Remove drawer screws on right and left sides (two screws
on each side).
Remove Hex
Head Drawer
Remove Hex
Head Drawer
Screw
_ CAUTION
Drawer is heavy. Use caution when lifting.
3. Lift drawer up and out to remove.
Installlng Freezer Drawer
1. With lower slides pulled out, hang drawer onto slide
brackets ensuring pins on each side are fully inserted into
slots on each side.
Drawer {_
Assembly
Pin
>
_ i.................................................._iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii¸
Fully Extend
Drawer Slides
_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiB_
Sl°tz ,_ iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
!..................._ iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
.
Reinstall four drawer screws (two per side), tighten down,
and close drawer (C).
Install Screws
(2) Each Side
,
4,
,
Check gasket seal around top, bottom, and sides of
freezer drawer.
If gasket is not sealed, open drawer and slightly loosen
four drawer screws (two on each side) to allow drawer to
rotate.
Close drawer and recheck the seal on the gasket (A).
Open the drawer grabbing by the sides in the center (B).
Be careful not to rotate the drawer.
_i i i i
il ii _ i
Push Against
Freezer Drawer
A ¸
_x
ii iii
ii'i_ili!i!iiii!i!i!i
6. Tighten four drawer screws.
7. Recheck gasket seal.
8. Install the toe grille by fitting into place.
12
Loading ...
Loading ...
Loading ...