Loading ...
Loading ...
Loading ...
CAUTION: To reduce the risk of serious bodily injury,
DO NOT use power tools to assemble the blades (I). If
overtightened, blades (I) may crack and break.
Place one blade plate (J) under blade (I), aligning
holes. Then, insert one motor screw/washer (BB) into
one of the holes at the end of the blade (I), turning until
the motor screw/washer (BB) comes through the other
side of the blade (I). Repeat with the other motor
screw/washer (BB).
Align the protruding ends of the motor screw/washers
(BB) with the corresponding holes on the underside of
the motor housing (D). Tighten both motor screws/
washers (BB).
Repeat for the other two blades (I).
NOTE: Make sure all blades (I) are completely
secure before proceeding.
10
Hardware Used
Blade Screw/Washer
x 6
BB
4.
5.
Remove one motor plate screw (E) from motor
plate on underside of motor housing (D) and
partially loosen the other two motor plate screws
(E). Align slotted holes in fitter plate (F) with
loosened motor plate screws, allowing molex
connections from motor housing (D) to come
through hole in fitter plate (F). Twist fitter plate (F)
to lock. Re-insert the motor plate screw (E) that
was removed and securely tighten all three motor
plate screws (E).
5
FINAL INSTALLATION
4
I
D
J
BB
D
E
E
F
Molex
Connections
Loading ...
Loading ...
Loading ...