Loading ...
Loading ...
Loading ...
Instructions
for the installer
8. ELECTRICAL CONNECTION
Make sure that the voltage and capacity of the power supply line conform to the
data shown on the plate located under the casing. Do not remove this plate
for any reason.
The plug at the end of the supply cable and the wall socket must be of the same
type and must conform to the applicable legislation on electrical
installations. Make sure that the supply line is suitably earthed.
Pass the power supply cable through the back of the unit, taking care that
it does not touch the bottom casing of the hob or the oven (if any)
installed underneath it.
Fit the power supply line with an omnipolar circuit breaker with a contact
opening gap equal to or greater than 3 mm in an easily accessible position close
to the appliance.
Avoid use of adapters and shunts.
If the power cable is replaced, the
cross- section of wires in the new cable
must be
no less than 0.75 mm
2
(3 x 0.75 cable),
remembering that the end for connection to
the appliance must have an earth wire
(yellow/green) which is at least 20 mm
longer.
Only use a H05V2V2-F or similar cable resistant to the maximum temperature of
90°C. Its replacement must be carried out be a specialised technician who must
carry out the connection to the power grid following the diagram below.
L = brown
N = blue
= yellow/green
The power supply cable must be replaced by an authorised service centre to
prevent any risks.
The manufacturer declines all responsibility for damage to persons or
things
caused by non-observance of the above prescriptions or by interference
with any part of the appliance.
20
Loading ...
Loading ...
Loading ...