Loading ...
Loading ...
Loading ...
RAISE THE BLADE (Fig. 29)
To raise or lower the blade, turn the blade
elevation handwheel (1)
COUNTER-CLOCKWISE.
NOTE: It is not necessary to loosen blade
tilting locking knob (2) when raising or
lowering the saw blade.
TILTING THE BLADE (Fig. 29)
1. Loosen blade bevel locking knob (2).
2. Slide the entire handwheel assembly (1)
to desired location.
3. Tighten blade bevel locking knob (2).
Ensure locking knob is fully tightened
before attempting a cut.
ON/OFF PADDLE SWITCH (Fig. 30)
The ON/OFF paddle switch has a removable
safety key. With the key removed from the
switch, unauthorized use is minimized.
1. To turn the saw ON, insert key (2) into the
slot above the switch. Move the paddle
switch (1) upward to the ON position.
Fig. 29 2
o o
Fig. 30
2
O O 3
--1
2. To turn the saw OFF, move the paddle switch (1) downward.
3. To tock the paddle switch in the OFF position, grasp the end of the removable key and
pull it out.
4. With the safety key removed, the ON/OFF switch will not operate.
5. If the key is removed while the saw is running, it can be turned OFF but cannot be
restarted without inserting the removable key (1).
OVERLOAD PROTECTION (Fig. 30)
This saw has a reset overload relay button (3) that will restart the motor after it shuts off
due to overloading or tow voltage. If the motor stops during operation, turn the ON/OFF
switch to the OFF position. Allow five minutes for the motor to cool. Push the reset
button (3) and turn the switch to the ON position.
TO AVOID INJURY AND TO PREVENT ACCIDENTAL STARTING WHEN THE
RESET BUTTON IS PUSHED, THE ON/OFF PADDLE SWITCH SHOULD BE IN THE
OFF POSITION AND THE PLUG REMOVED FROM THE POWER SOURCE WHILE
THE COOL DOWN TAKES PLACE. OVERHEATING MAY BE CAUSED BY AN
UNDER-SIZED EXTENSION CORD, AN EXTENSION CORD TOO LONG IN LENGTH,
MISALIGNED PARTS OR A DULL BLADE. INSPECT YOUR SAW FOR PROPER
SET-UP BEFORE USING IT AGAIN.
Loading ...
Loading ...
Loading ...