Loading ...
Loading ...
Loading ...
,
Assemble latch lever to rear tongue using 5/16" x 4"
hex bolt and 5/16" lock nut. Tighten nut until snug
against side of rear tongue. See figure 1A.
Attach the spring to the hole in the latch lock lever
and the hole in the tongue. See figure lB.
SPRING
,
Assemble a washer, wheel (valve stem facing out)
and another washer onto the axle as shown in figure
3. Secure the wheel in place using a cotter pin.
Repeat for other wheel.
WHEEL
AXLE
FLAT --_ \
WASHER
FIGURE 3
COTTER PiN
FLAT
WASHER
5,
Assemble the latch stand plate and latch stand
bracket (with alignment tab toward rear of cart) to the
cart try using four 1/4" x 3/4" hex bolts, 1/4" washers
and 1/4" nylock nuts. Tighten nuts after all bolts are
in place. See figure 4.
FIGURE 1
,
Assemble the rear tongue to the wheel support by
sliding the axle through the holes in the tongue and
wheel support as shown in figure 2.
FIGURE 4
1/4" NYLOCK NUT
FIGURE 2
Loading ...
Loading ...
Loading ...