Loading ...
Loading ...
Loading ...
14.Secureropearoundbottomofcart.Usethelanyardto
tightenropeuntilitfirmlysecuresthecartcovertothe
cart.Seefigure22.
15.Ensurelanyardislockedtokeepropeinplace.See
figure22.
NOTE:Cartbagriotshownforclarity.
2NDLOWER
SUPPORTROD
SECURE
ROPE
LOCK/UNLOCK
FIGURE22
ASSEMBLING THE #62468 DECK ADAPTER
TOTHE MOWER DECK
NOTE: Not all of the parts in the deck adapter hardware
package will be used for any one particular fit up.
Remove the mower discharge deflector from your
mower deck. Save the deflector and hardware for
remounting deflector.
CAUTION: Mower deflector must be
replaced when Vac System deck adapter
is removed. Do Not operate mower
unless adapter or deflector is in place and
properly mounted.
FITTING TO SEARS TRACTORS
The yellow fold out sheet contains the templates for
Sears tractors only. (The white fold out sheets include all
templates, including other tractor brands.)
ff you have a Murray brand tractor with a 38" 40" or 46"
deck, go directly to the instructions on page 17.
Identify and cut out the template for your brand and
size mower deck. If there is no template included for
your deck size, you can make your own template by
marking around a piece of cardboard held against the
edge of the deck's discharge opening.
FOLLOW THE iNSTRUCTIONS PRINTED ON THE
TEMPLATE. If there are no instructions, use the
following instructions as a general guide.
Tape the template to the face of the adapter, about
1/2" from front and 1/4" down from top for deeper
decks. For shallow decks, position template low
enough that adapter will not extend below bottom
of deck. Mark outline of template on face of adapter
using white crayon, nail or scriber. Drill a starting hole
inside the outline, then use a saber saw or key hole
saw to cut out the opening. See figure 23.
1/4" DOWN
IMPORTANT: Keep cut-off as close to
the top edge as possible,
1/2" FROM FRONT
FIGURE 23
15
Loading ...
Loading ...
Loading ...