Loading ...
Loading ...
Loading ...
FENCE PIVOT ADJUSTMENTS
COMBINATION
MITER SQUARE
TABLE
VIEWOF BLADE NOTSQUARE WITH MITER
TABLE, ADJUSTMENTS ARE REQUIRED
Fig. 23
• Using a 10 mm wrench or adiustable wrench,
loosen the lock nut securing positive stop adjust-
ment screw. Also loosen bevel lock knob.
• Adjust positive stop adjustment screw to bring
saw blade into alignment with the square. See
Figure 24.
POSITIVESTOP
ADJUSTMENT
SCREWFOR
45°ANGLES
NUT(S)
Fig. 24
• Retighten bevel lock knob. Next, retighten lock nut
securing the positive stop adjustment screw.
Recheck blade-to-table alignment.
Note: These adjustments were made at the factory
and normally do not require readjustment.
Your saw has three scale indicators, two on either
side of the bevel scale and one on the miter scale.
After squaring adjustments have been made, it may
be necessary to loosen the indicators screws and
TRAVEL PIVOT ADJUSTMENT
• The saw arm should rise completely to the up
position by itself.
If the saw arm does not raise by itself or if there is
play in the pivot joints, have saw repaired by a
qualified service technician at your nearest Sears
store to avoid risk of personal injury.
BEVEL PIVOT ADJUSTMENT
• Your compound miter saw should bevel easily by
loosening the bevel lock knob and tilting the saw
arm to the left.
If movement is tight or if there is play in the pivot,
have saw repaired by a qualified service techni-
cian at your nearest Sears store to avoidrisk of
personalinjury.
DEPTH STOP
The depth stop limits the blade's downward travel, It
allows the blade to go below the miter table enough to
maintain full cutting capacities. The depth stop posi-
tions the blade 1/4 in. from the miter table support.
Note: The miter table supportis located inside miter
table.
The depth stop is factory set to provide maximum
cuttingcapacity for the 10 in. saw blade provided with
your saw. Therefore, the saw blade provided should
never need adjustments.
However, when the diameter of the blade has been
reduced due to sharpening, it may be necessary to
adjust the depth stop to provide maximum cutting
capacity. Also, when a new blade is installed, itis
necessary to check the clearance of the blade to the
miter table support before starting the saw. Make
adjustments if needed.
DEPTH STOP ADJUSTMENTS
See Figure 25.
• Unplug your saw.
_i, WARNING: Failure to unplug your saw could
result in accidental starting causing possible
serious personal injury.
Note: The above procedure can be used to check
blade squareness of the saw blade to the miter
table at both 0° and 45° angles.
reset them to zero.
To adjust the depth stop use a 17 mm wrench or
adjustable wrench and loosen the hex nut at the
rear of the miter saw arm.
Use the 5 mm hex key wrench provided to adjust
the depth stop adjustment screw. The saw blade
is lowered by turning the screw counter-clockwise
and raised by turning the screwclockwise.
18
Loading ...
Loading ...
Loading ...