Loading ...
Loading ...
Loading ...
5. Locate bevel indicator and 10.24x1/4 pan
cross hd. screw in loose parts bag.
6. Install bevel indicator and screw as shown
using a phillips screwdriver.
NOTE: This unit comes with the Band Saw blade
installed, assembly continues on p. 10, "Tension-
ing the Blade."
REPLACING THE BLADE
1.
,
Loosen the guide bar lock knob and position
the upper guide assembly approximately one
inch above the table and tighten lock knob.
Loosen the two blade guard mounting screws
and remove the blade guard.
t t \ GU,OEBAR
| I_ _ LOCKKNOB
BLADEGUARD UPPERGUIDE
T
, Loosen the guide bar lock knob and position
the upper guide assembly approximately two
inches above the table as shown and tighten
the lock knob.
GUIDEBAR
LOCK
,
Remove table insert, truss head screw, wash-
er and wing nut from the table (See Assem-
bly, p. 13 - "Adjusting the Table"). Replace
these parts after the blade is installed, ten-
sioned and tracked.
UPPER GUIDE
ASSEMBLY
5. Loosen the two screws in the front of the
upper blade guide assembly that secure the
blade guides and separate them about 1/8".
6. Loosen the two screws in the side of the
upper guide assembly and slide guides and
thrust bearing all of the way back.
7. Tighten all screws.
8. Loosen the three (3) cover knobs by turning
counterclockwise and remove cover.
NOTE: Replace the bandsaw cover after blade is
properly installed, tensioned and tracked.
"--d-
KNOB
9
I COVER
KNOB
COVER
t FRAME
Loading ...
Loading ...
Loading ...