Loading ...
Loading ...
Loading ...
DRBVE BELT TENSION
WARNING: TO AVOID iNJURY DUE TO ACCi-
DENTAL START, UNPLUG TOOL BEFORE
MAKING ADJUSTMENTS.
The tension on the drive belt has been set at the
factory, if adjustment is needed, use a 3;16" hex
wrench to loosen upper and lower cap screws,
Pult motor away from drive wheel to apply proper
tension to drive bett. Retighten cap screw while
holding motor in place
/Io/ ;O r
ADJUSTING THE TABLE
1. Replace the blade guard on the upper assem-
bly and tighten screws_
2. Locate the table insert and piace it in the
opening in the table. A!gn slot in the insert
with the s_ot in the tabte.
. Locate a I/4 - 20 x 314" truss head screw, a
ftat washer, and a 1/4 - 20 wing nut in loose
parts_ Insert screw into hole in tab!e top as
illustrated
4. From the underside of the table, install wash-
er and wing nut onto the truss head screw
and tighten finger tight. This will keep the
table flat and in alignment.
5, Replace the band saw cover,
erring to know your band
saw
2 3
COVER
KNOBS BLADE
,U_DES
TABLE
6
LOCK
KNOBS
FRONT
13
TRUNN!0N
BACK
7
BEVEL
SCALE
Loading ...
Loading ...
Loading ...