Loading ...
Loading ...
Loading ...
Set [ : Time-lapse movie] to [Disable] if you will connect the camera to a
computer with the interface cable and use EOS Utility (EOS software). Options
other than [Disable] will prevent the camera from communicating with the
computer.
Image stabilization is not applied in time-lapse movie recording.
Time-lapse movie shooting ends if the power switch is set to < >, for example,
and the setting is changed to [Disable].
Even if a flash is used, it will not fire.
The following operations cancel standby for time-lapse movie recording and switch
the setting to [Disable].
• Selecting either [Clean now ] in [ : Sensor cleaning] or [Basic settings]
in [Reset camera]
Image quality may be lower if you start time-lapse movie recording while the white
[ ] temperature warning icon ( ) is displayed. It is recommended that you start
time-lapse movie recording after the white [ ] icon disappears (camera’s internal
temperature decreases).
With [Auto exposure] set to [Each frame], the ISO speed, shutter speed, and
aperture value may not be recorded in the time-lapse movie Exif information in
some shooting modes.
Note
You can use Wireless Remote Control BR-E1 (sold separately) to start and stop
time-lapse movie recording.
With Wireless Remote Control BR-E1
First, pair Wireless Remote Control BR-E1 with the camera ( ).
Set [ : Remote control] to [Enable].
After you take some test shots and the camera is ready to shoot (as in step
13,
), set the release timing/movie shooting switch on the BR-E1 to <●>
(immediate release) or <2> (2-sec. delay).
If the remote control’s switch has been set to < >, the time-lapse movie
recording cannot start.
Camera Status/Remote
Control Setting
<●> Immediate Release
<2> 2-sec. Delay
<
> Movie Recording
Test-recording screen Test recording To recording standby
Recording standby Starts recording To test-recording screen
During time-lapse movie
recording
Ends recording Ends recording
346
Loading ...
Loading ...
Loading ...