Loading ...
Loading ...
Loading ...
5 Using a garden hose, remove additional debris by
back flushing water through nozzle extension.
Back flush between 30 to 60 seconds.
Reinstall spray tip and in-line filter into nozzle
extension.
.
7. Reconnect nozzle extension to spray gun.
8. Reconnect water supply, turn on water, and start
engine.
9. Test pressure washer by operating with each
Quick Connect spray tips.
O-Ring Maintenance
Purchase an O-Ring Repair Kit, item number 71-75116,
at your local Sears or by calling 1-8go-366-PART or
online at www.sears.com. It is not included with the
cleaning system. This kit includes replacement o-rings,
rubber washer and water inlet filter. Refer to the
instruction sheet provided in the kit to service your unit's
o-dngs.
PUMP MAINTENANCE
Changing Pump Oil
Change oilevery 50 hours or once yearly, whichever
occurs first.
NOTE: You must purchase a premeasured bottle of
pump oil, item number 190585GS, by calling
1-800-366-PART or online at www sears com
Change pump oil as follows:
1 Drain engine oil and fuel from pressure washer.
2 Use a 8mm allen wrench to remove black pump
oil cap between high pressure outlet and garden
hose inlet.
Oil Cap
3. Tilt pressure washer to drain oil into an approved
container until it drips slowly from pump.
4. Tilt pressure washer in opposite direction and
empty premeasured pump oil bottle into same
opening (a small funnel may be helpful).
5. Install black pump oil cap and tighten firmly.
6. Set pressure washer in upright position. Add fuel
and engine oil.
ENGINE MAINTENANCE
Checking Oil Level
Oil level should be checked prior to each use or at
least every 8 hours of operation. Keep oil level
maintained.
Changing Oil
Change engine oil after the first 5 hours and every
50 hours thereafter. If you are using your pressure
washer under extremely dirty or dusty conditions, or in
extremely hot weather, change oil more often
CAUTION
Used motor oil has been shown to cause skin cancer in
certain laboratory animals.
Thoroughly wash exposed areas with soap and water.
KEEP OUT OF REACH OF CHILDREN
DON'T POLLUTE. CONSERVE
RESOURCES. RETURN USED OIL TO
)COLLECTION CENTERS
Change oil while engine isstill warm from running, as
follows:
1 Drain fuel tank by running pressure washer until
fuel tank is empty
2 Disconnect spark plug wire and keep it away from
spark plug.
3. Clean area around oil fill, remove oil fill
cap/dipstick. Wipe dipstick clean
4. Tip your pressure washer to drain oil from oil fill
into a suitable container making sure you tip your
unit away from spark plug and air cleaner When
crankcase is empty, return pressure washer to
upright position.
5 Wipe dipstick clean, insert it intooil fill hole and
tighten securely, remove dipstick. Add
recommended oil up to "Full" mark on dipstick.
Pour slowly. Wipe dipstick clean each time oil
level is checked DO NOT overfill
6 Install oil fill plug and dipstick, tighten securely.
7 Wipe up any remaining oil
8 Reconnect spark plug wire to spark plug
14
Loading ...
Loading ...
Loading ...