Loading ...
Loading ...
Loading ...
Your newtractor has been assembled at the factorywith exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your
tractor all parts and hardware.you assemble must be tightened securely. Use the
correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes you need
are listed below.
(1) 9/16"wrench (1) Pliers
(2) 1/2"wrench (1) Utility knife
(1) Tire pressure gauge
When right or left hand is mentioned in
this manual, it means, from your pointof
view,when you are in the operating
position (seated behind the steering
wheel).
TO REMOVETRACTOR FROM
CARTON
UNPACK CARTON
1. Remove all accessible loose parts
and parts cartons from carton.
2. Cut, from top to bottom, along lines on
all fourcorners of carton, and lay
panels flat.
3. Check for any additional loose parts
or cartons and remove.
7. Snap steering wheel insert intocenter
of steering wheel.
8, Remove protective materials from
tractor hood and grill.
IMPORTANT: Check for and remove any
staples in skidthat may puncture tires
where tractor isto roll oftskid.
3/8 HexBolt
_--_ Lock Washer
_'_-._ LargeRat
_ Washer
o
BEFORE REMOVINGTRACTOR
FROM SKID
A'n'ACH STEERINGWHEEL
ASSEMBLE EXTENSION SHAFT AND
BOOT
1. Slide extension shaft onto lower
steering shaft. Align mounting holes
in extension and lower shafts and
install5/16 hex bolt and Iocknut.
Tighten securely.
IMPORTANT: Tighten bolt and nut
securelyto 18-22 ft. Ibstorque.
2. Piece tabs ofsteering boot over tab
slotsin dash and push down to
secure.
INSTALL STEERING WHEEL
3. Position trontwheels of the tractor so
they are pointing straightforward.
4. Remove steering wheel adaptor from
steering wheel and slide adapter onto
steering shaft extension.
5. Position steering wheel so cross bars
are horizontal (left to right) and slide
inside boot and onto adapter.
6. Assemble large flat washer, 3/8 lock
washer, 3/8 hex bolt and tighten
securely.
5/16 Locknut
Slots
HOWTO SET UPYOURTRACTOR
CHECK BATI'ERY
1. Lift seat pan to raisedposition and
open battery box door.
NOTE: It this batteryis put intoservice
after month and year indicated on label
(label located between terminals) charge
battery forminimum of one hour at 6-10
amps. (See "BA'I-rERY" in Maintenance
section of this manual for charging
instructions).
Label
Battery
Door
Loading ...
Loading ...
Loading ...