Loading ...
Loading ...
Loading ...
,_CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
1. Depress clutch/broke pedal fully and set parking brake.
2. Place gearshift lever in neutral (N) position.
3. Place attachment clutch in "DISENGAGED" position,
4. Turn ignitionkey "OFF" and remove key.
5. Make sure the blades and all moving pads have completely stopped,
6, Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with ptug.
TRACTOR
TO REMOVE MOWER
Mower will be easier to remove from the
rightside oftractor.
1. Place attachment clutch in =DISEN-
GAGED" position.
2. Move attachment liftlever forward to
lower mower to its lowest position.
3. Roll belt off engine pulley.
4. Remove small retainer spring, and lift
clutch spdng off pulley bolt.
5. Remove large retainer spring, slide
collar off and push housing guide out
of bracket.
6. Disconnect anti-swaybar from chassis
bracket by removing retainer spring.
7. Disconnect suspension arms from
roar deck brackets by removing
retainer spdngs.
8. Disconnect front links from deck by
removing retainer spdngs.
9. Raise lift lever to raise suspension
arms. Slide mower out from under
tractor.
IMPORTANT: Itan attachment other than
the mower deck is to be mounted on the
tractor,remove the front links and hook
the clutchspdng Into square hole in
frame.
TO INSTALL MOWER
1. Raise attachment lift lever to its
highest position.
2. Slide mower under tractor with
deflector shield to rightside of tractor.
3. Lower liftlever to its lowest position.
4. Install mower in reverse order of
removal instructions.
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked
on level ground or driveway. Make sure
tires are properly inflated (See "PROD-
UCT SPECIFICATIONS" sectionof this
manual). If tires are over or
underinflated, you will not properly adjust
your mower.
SIDE-TO-SIDE ADJUSTMENT
• Raise mower to its highest position.
• At the midpointof both sidesof mower,
measure height from bottom edge of
mower to ground. Distance "A"on
both sides of mower should be the
same or within 1/4" of each other.
Small Retainer Spdng
Clutch S
Square Hole
Retainer S
Anti.Sway
Collar
(Both Sides)
Housing Guide
Large Retainer Spring
21
Loading ...
Loading ...
Loading ...