Loading ...
Loading ...
Loading ...
Add Rinse Aid
M
M
• Your dishwasher isdesigned to use rinse aid for good drying
performance. Without rinse aid, your dishes and dishwasher
interiorwill have excessive moisture.
• Rinse aid keeps water from forming droplets that can dry as
spots or streaks. They also improve drying by allowing water to
drain off of the dishes after the final rinse.
• Rinse aid helps to reduce excess moisture on the dish racks
and interior of your dishwasher.
• When the dispenser is low and needs to be • RinseAidLow
refilled,an indicator light on the control panel
will illuminate.
• To add rinse aid, turn
the dispenser cap a 1/_
turn counterclockwise
and remove. Pour
rinse aid intothe
opening untilthe liquid
reaches the FULL
levelmarking. Replace
the dispenser cap and
turn clockwise until
the cap issecure.
¼ turnto lock
RinseAid
NOTE: For most water conditions, the factory setting of 2 will give
good results.
Select a Cycle (cycles vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
Heavier cycles and options affect cycle length. Some cycles and
options willtake up to 21_ hours to complete.
_'zff4j_
Select Options (options vary by model)
See "Cycle and Option Descriptions" charts in the following
section,
You can customize your cycles by pressing the options desired, To
Cancel an option, press it again,
Start or Resume a Cycle
• Run hot water at the sink nearest your dishwasher until
the water ishot. Turn off water.
• Select the wash cycle and options desired.
Press START/RESUME button once and close the drawer. After
a brief pause, the cycle will begin. The drawer must be closed
within 3 seconds after pushing START/RESUME or the lights
will flash, atone will sound, and the dishwasher will not begin.
Press the START/RESUME button again and shut the drawer
within 3 seconds.
• You can add an item anytime before the main wash starts.
Open the drawer slowly and add the item. Press the START/
RESUME then close the drawer.
NOTE: If you have a two drawer dishwasher model, each drawer
has its own controls and can run independently of the other.
4
Loading ...
Loading ...
Loading ...