Loading ...
Loading ...
Loading ...
YourWasherhastriedtofillbutwas
unsuccessful.
Problem with control.
A fault is detected in the water level
sensor.
Jammed Key.
Motor speed sensor problem.
Highcurrentdetected
Motor not running properly.
Temperature sensor problem.
High/Low voltage detected.
SilverCare TM control problem
System error.
Too many suds are detected during the
washing session.
The unit is put on hold until the suds
are reduced. Then, the unit will go back
to the operation.
When it finishes washing, End and
SUdS codes will blink in turn.
For any codes not listed above, call 1-800-726-7864 (1-800-SAMSUNG)
Make sure the water faucets are open all
the way. Check for kinked hoses.
Check the inlet screens on the fill hoses.
f you use a Flood Safety Device, then
_lease remove the device and connect
:he water hoses directly to the unit.
Call for service.
Call for service
Call for service
Restart the cycle pressing the Start/
Pause Button. If the code reappears,
call for service.
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
Call for service.
To prevent it, cut down on detergents.
Troubleshooting 27
Loading ...
Loading ...
Loading ...