Loading ...
Loading ...
Loading ...
na VOLArw her
J
2. Check the inlet hose to ensure a washer is inside each fill
hose. Cold
Thread the inlet hoses to the HOT and COLD faucet
connections.
On the other end of the hose, check for one rubber washer
per hose and install each fill hose to the water valve. Make
sure the hose with the Hot printed line is attached to the
HOT faucet. Tighten by hand until snug, then two-thirds of a
turn with pliers.
For correct water use, connect both HOT and COLD water
valves. If either or both are not connected, an "nF" (no fill)
error can occur. Oold printed
3. Turn on the "HOT" and "COLD "water supply and check all
connections at the water valve and the faucet for leaks.
Hot
4. Plug the power cord into a 3-Prong, well grounded 120
volt 60 Hz approved electrical outlet protected by a 15-
amp fuse or comparable circuit breaker.
Your washer is grounded through the third prong of the
power cord when plugged into a three-prong grounded
receptacle.
5. Slide your washer into position.
6. Level your washer by turning the leveling legs in or out as
necessary by hand or by using the wrench included with
your washer.
When your washer is level, tighten the locking nuts using
the wrench or (-) flathead screwdriver.
[_ Your Washer must be leveled on all four sides. A
carpenter's level should be used on all four corners of
your Washer. It's a good idea after the first dozen washes
to recheck your washer's levelness.
(_ Avoid damage to the legs. Do not move
the Washer unless the Locking-nuts are
fastened to the bottom of the Washer.
i!!!!i!ii!!i¸ll;i_i_;;ii_l%!i!i!llili!!i!i!i!_iill_lililililill_l_iiiililii_ilil!lili_i_iiil!_!_l_iililil_ili_l_ii_
12 Installing your washer
Loading ...
Loading ...
Loading ...