Loading ...
Loading ...
Loading ...
Programming
Remote Control
Below are the steps to program a new or existing remote control. Test
remote control before reprogramming.
1. Press and release the LEARN Button on the
garage door opener.
2. Press and hold the button on the remote
control that you wish to use. Release the
button when the garage door opener lights
blink or two clicks are heard.
OR
For Multi-Function Control Panel 882LMW
LEARN Button
1. Press the LEARN button on the
door control to enter
Programming Mode.
2. Press the LEARN button again, the
LED will flash once.
3. Press the button on the remote
control that you wish to operate
your garage door.
OR
For Push Button Door Control 883LMW
Push Button
Light/Learn
Button
1. Press and hold the Light button
and the Push button until the
Push button LED begins to blink.
2. Press the button on the remote
control that you wish to operate
your garage door.
If your vehicle is equipped with a
Homelink
®
, you may require an external adapter depending on the
make, model, and year of your vehicle.
Visit www.homelink.com for additional information.
Wireless Keyless Entry
Refer to the instructions provided with your keyless entry OR go to
LiftMaster.com to download instructions.
To Erase the Memory
LEARN
Button
Erase ALL Remote Controls and
Keyless Entries
Press and hold the LEARN button until
the LED goes out (approximately 6
seconds).
All remote controls and keyless entries are now erased.
Erase ALL Devices (Including myQ® enabled accessories)
1. Press and hold the LEARN button until the LED goes out
(approximately 6 seconds).
2. Immediately press and hold the LEARN button until the LED goes
out. All codes are now erased.
Adjustment
Button
Erase the Wi-Fi Network from the
Garage Door Opener
Press and hold the adjustment button
until 3 beeps are heard
(approximately 6 seconds).
7
Loading ...
Loading ...
Loading ...