Loading ...
Loading ...
Loading ...
Mounting enclosure (gas bottle compartment adjacent)
Mounting enclosure (gas bottle compartment underneath)
Enclosure construction
• All materials used for the construction of the enclosure
and gas bottle compartment must be non-combustible.
• A 40mm min. gap between the enclosure and rear wall
is required. This allows for venting of both the barbecue
and gas bottle compartment. Vents should also be
positioned at the front of the enclosure.
• The appliance can be supported by either hanging from
the benchtop (hanging brackets supplied) or sitting
the appliance on a support frame that is built in to the
enclosure.
Enclosure ventilation requirements
AS5601 ventilation requirements for 9kg cylinder storage are:
• Where of sheet metal or similar impervious construction
there shall be ventilation openings at the top and bottom
of the enclosure or recess, each opening providing a
free area of at least 200cm
2
for every cylinder enclosed.
• For LPG installations having enclosed cabinetry below
the separation panel that does not contain a gas bottle,
low level venting must be installed. This is to allow
the gas which is heavier than air to escape from the
enclosure in the situation where there may be a leak.
A minimum opening of 200cm
2
is required.
MOUNTING ENCLOSURE GUIDELINES
828mm 4 burner
630mm min.
230mm50mm min.
520mm
Support frame for
barbecue base
40mm
min. gap
793mm 4 burner
1006mm 5 burner
971mm 5 burner
Gas bottle compartment
venting slots
Barbecue
venting slots
930mm min.
Rear wall / splashback
to be non-combustible
material
Low level
venting
828mm 4 burner
793mm 4 burner
1006mm 5 burner
971mm 5 burner
Barbecue
venting slots
100mm min.
Gas bottle compartment
venting slots
Gas bottle
compartment
venting slots
Gas bottle
compartment
venting slots
930mm min.
Rear wall / splashback
to be non-combustible
material
630mm min.
520mm
40mm
gap
Support frame for
barbecue base
230mm100mm min.
11MOUNTING ENCLOSURE GUIDELINES
Loading ...
Loading ...
Loading ...