Loading ...
Loading ...
Loading ...
INSTALLATION WARNINGS
WARNING
• This appliance shall only be used in an above ground,
open air situation with natural ventilation without
stagnant areas, where gas leakage and products of
combustion are rapidly dispersed by wind or natural
convection. This barbecue has been designed for
outdoor use only. Failure to adhere to these installation
instructions may cause injury or property damage
and affect your ability to make a claim under the
manufacturer’s warranty. Refer to diagrams below.
• Never install this barbecue inside any building,
garage, shed or breezeway or inside a boat, caravan or
recreational vehicle. This is to prevent the possibility of
fire or carbon monoxide poisoning or asphyxiation.
• Any enclosure in which this appliance is installed shall
comply with one of the following:
– An enclosure with walls on all sides, but at least
one permanent opening at the ground level and no
overhead covering
– Within a partial enclosure that includes an overhead
cover and no more than 2 walls
– Within a partial enclosure that includes an overhead
cover and more than 2 walls, the following shall apply:
– At least 25% of the total wall area is completely open
and at least 30% of the remaining wall area is open
and unrestricted
• In the case of balconies, at least 20% of the total of the
side, back and front wall areas shall be and remain open
and unrestricted.
Outdoor area
example 1
Outdoor area
example 2
Outdoor area
example 3
both ends
open
open side at
least 25% of
total wall area
open side at
least 25% of
total wall area
Outdoor area
example 4
Outdoor area
example 5
30% or more
in total of the
remaining wall
area is open and
unrestricted
30% or more
in total of the
remaining wall
area is open and
unrestricted
Choosing a location
When planning the location and preparing the installation
structure for this appliance note the following:
• This appliance must be installed in accordance with
Australian Standard AS 5601 and in accordance with
local authority.
• Requirements in these instructions for clearances
to combustible materials also apply to combustible
materials that have non-combustible materials attached
to their surface.
• The minimum clearance from combustible construction
materials to all sides of the appliance is 450mm.
• The minimum clearance to a vertical wall above bench
level that is made from combustible material is 450mm.
• The vertical clearance above the cooking surface to any
combustible materials must be at least 1000mm.
• When using LPG in an enclosure ventilation must be
provided. Gas is highly explosive and can cause serious
injury and damage to property if allowed to accumulate
and then be ignited.
• Avoid windy positions as this will affect cooking
performance and burner efficiency. If this situation
cannot be avoided some shielding may be necessary.
Natural gas requirements
• The enclosure must be constructed so that access can
be gained to the natural gas regulator at all times.
10 INSTALLATION WARNINGS
Loading ...
Loading ...
Loading ...