Loading ...
Loading ...
Loading ...
10. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable). Test
fan speeds with the pull chain on switch
housing located to the RIGHT of the reverse
switch (labeled FAN). Start at the OFF position
(no blade movement). First pull will set the fan
to HI. Second pull will set the fan to MEDIUM.
Third pull will set the fan to LOW. Fourth pull
will again set the fan to OFF setting. If
applicable, test light with pull chain on switch
housing located to the LEFT of the reverse
switch (labeled LIGHT). (diagram 1) If fan
and/or light do/does not function, please refer
to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the
reverse switch (located on switch housing).
Set reverse switch to recirculate air depending
on the season:
- DOWN position in summer
(diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to
function. If the reverse switch is set in the
middle position (diagram 4), fan will not
operate.
Attach pull chain extension(s) supplied or
custom pull chain extension(s) (sold
separately) to end(s) of the pull chain(s).
page 8
diagram 2
diagram 3
diagram 4
diagram 1
fan pull chain
extension
light pull
chain extension
motor housing
reverse
switch
switch
housing
Loading ...