Loading ...
Loading ...
Loading ...
Beforeyoucall forservice...
PossibleCauses What ToDo
IYas_r _ tmisy Washer is uneven • To level the front of the washer, adjust the front leveling
legs by rotating the individual leg in the proper direction
for up or down. To level back of washer, lift back of
machine 4" (11 can) and set down.
Washer load is • Press PAUSE to stop the washer, open the lid and
unbalanced redistribute the load evenly. Close the lid and press
SI'ART.
Shipping rod is still assembled • To remove shipping rod from washer, pull yellow tag and
in unit attached rod from the bottom right hand side of washer.
Washer is sitting too dose • Pull washer away from the wall; about 4" (l 1cm)
to wall (causes knocking is needed.
duri_g cycle)
PerfecTempfeature • This is normal. PerfecTempturns water valves off and on
is being used to adjust water temperature.
WhatToDo
OccasionaRy the adhesive
used on the labeis does
not release cleanly
• Use a hair dryer set at the lowest heat setting, directing
the air at the label for a short amount of time. This will
release the adhesive easily, without damaging the surface
of the washer.
16
Loading ...
Loading ...
Loading ...