Loading ...
Loading ...
Loading ...
PossibleCauses
What ToDo
_:tea/rs
Type of detergent
Verysoft water
Too much detergent
F'dlhoses or drainhose is
improperly connected
Household drain may
be dogged
Constant water pressure
to the fill hoses at the
water source
Using too much detergent
in washer
Control is not setproperly
• Switch to a lower sudsing detergent brand and follow
instructions on package,
• Try less detergent.
• Measure your detergent carefully. Use less soap ffyou
have soft water, a smaller load, or a lightly soiled load.
• Make sure hose connections are fight at faucets
and at washer.
• Make sure end of drain hose is properly connected
to washer and correctly inserted in and secured to
drain facility.
* Check household plumbing. You may need to call a
plumber.
• Tighten hoses at the faucets and mm the water offafter
each use.
• Check condition of the fill hoses; they may need
replacement after 5 yemx
• Use less detergent. Use less soap ffyou have soft water, a
smaller load, or a lightly soiled load.
• Check water temperature control and adjust.
Water supplyis turned off
orimproperly co,mected
Water valve screem are
stopped up
• Turn both hot mad cold faucets fully on and make sure
hoses are connected to correct faucets.
• Turn off the water source and remove the water connection
hoses from the upper back of the washer. Use a brush or
toothpick to clean die screens in the machine. Reconnect
the hoses and mrn the water back on.
House waterheater is
notset properly
• Make sure house water heater is delivering water
at 120°F.-140°F.(48°C.-60°C.).
PeWecTemp featm'e was
not activated
• The lid mttst be closed for Pedectempto work.
Lidlifted or cyclewas put in
pause for over 24 horns
• Reset cycle.
Drainhose iskinked or
improperly connected
• Straighten drain hose and make sure washer is not sitting
on it.
• Top of drain outlet should beless than 8fl (2.5 m)
above floor.
Washer in spin cycle • Spray rinse during a spin cycle is normal.
Kxa-e_ely low water pressure
Inlet hoses are kinked
Water valve screens are
stopped up
Drain stand pipe is too low
• Press the START button again.
• Straighten hoses.
• Yum off the water source and remove the water connection
hoses from the upper back of the washer, Use a brush or
toothpick to clean the screens in the machine. Recolmect
the hoses and turn the water back on.
• Drain stand pipe must be above 30".
/g
Loading ...
Loading ...
Loading ...