Loading ...
Loading ...
16.
STYLE B GAS VALVE CONVERSION
Observe the cover dial settings indicated as NG (Natural
gas) and LPG (Liquefied Propane gas) along with the gas
type indicator. See Figure 5.
"LPG"
SETTING
"NG"
17.
COVER DIAL
SE_ING INDICATOR
Figure 5
Position a pair of bend pliers into the slots of the cover dial.
See Figure 6.
18.
Figure 6
Rotate cover dial 25 degrees counter clockwise lining up
"LPG" marking with the indicator on the gas valve.
See Figure 7.
"LPG"
SETTING
INDICATOR
Figure 7
19. Apply English or French conversion label on top of the
burner data decal located on the burner baseptate.
20.
Install the complete burner assembly back into dryer. Be
sure all wires are properly connected. Reconnect the
flexible gas line from burner assembly or manual gas
valve depending on your application.
IMPORTANT: Be sure to tighten union nut properly, gas
leakage could occur.
installation Checklist
Check that both labels have been installed as described in
steps 2 and 19.
If converting to Propane, check that the number 62 is not
marked on either of the remaining orifices. If converting to
Butane, check that the number 64 is not marked on either
of the remaining orifices.
Check that the regulator vent cap has been replaced by
the blocking pin as in Figure 4. (Style "A" valve only).
Explosion Hazard
Use a new CSA |nternational approved gas supply line.
Install a shut-off vatve.
Securely tighten all gas connections.
if connected to LP, Ihavea qualified person make sure
gas pressure d_s not exceed 13" (33 cm) water
column,.
E×amplea of a qualified parson include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in _ath, explosion, or fire.
Pressure Test
Check minimum and maximum inlet gas pressures:
• Remove pressure tap plug from gas valve body.
• Insert pressure tap finger tighten and connect monometer
hose to the end of the nipple.
• Turn on gas supply. If your dryer is equipped with manual
valve, make sure that it is in the on position.
• Verify gas inlet pressure is between 8" and 13" water
column.
• Turn off gas supply. If your dryer is equipped with manual
valve, make sure that it is in the off position.
• Remove monometer and pressure tap and replace plug.
W10436338A 3
Loading ...