Loading ...
CHANGING THE ORiFiCE ONEPIECE
COiL
9. Remove the burner tube assembly by removing the
screws that hold it to the base and bracket assembly.
Care should be used when removing the burner assembly
so as not to bump the ceramic ignitor (located next to
burner flame spreader) as it can be broken or cracked by
impact.
NOTE: The ignitor is fragile.
10.
Remove the burner orifice from the valve and replace it
with the proper orifice furnished in this kit. Orifice number
is stamped on one edge of the hex head of orifice.
Securely tighten. See Figure 1.
CAP - PERMANTELY
FIXED TO VALVE
COVER DiAL
Figure 2- STYLE "B'
NOTE: iF YOUR GAS DRYER HAS STYLE "A"
FOLLOW STEPS 13 TO 15. FOR STYLE "B", SKIP TO
STEPS 16 TO 19.
11.
12.
Figure 1
Use No. 347744 Orifice for Butane gas No. 64
Use 347743 Orifice for Propane gas No. 62.
Put the burner tube back on the burner assembly.
Securely tighten the two (2) mounting screws.
Before proceeding, you must first determine which gas
valve style is on the dryer. Refer to Figure 2 - Style "A"
and "B".
LEAK LIMITER
DEVICE
13.
STYLE A GAS VALVE CONVERSION
Remove the regulator vent cap (leak limiting device) from
the pressure regulator. See Figure 3.
LEAK LIMITING
DEVICE .....
GAS VALVE
REGULATOR .....
14.
xX //
Figure 3
Install the new blocking pin finger-tight. Do not tighten
more than 1/8 turn to seal it. See Figure 4.
BLOCKING
PIN
GAS VALVE
REGULATOR
TWO SEPARATE
COILS
Figure 2 - STYLE "A"
15.
i
--\\\\\\ j
Figure 4
Apply English or French conversion decal on top of the
burner data decal located on the burner baseplate.
Proceed to step 20.
2 W10436338A
Loading ...
Loading ...