Loading ...
Loading ...
Loading ...
9
SETTING UP YOUR KEGERATOR
CO
2
Regulator and CO
2
Cylinder
NOTE: The CO
2
cylinder is shipped empty to avoid any possible
accidents during transportation. When you purchase the first keg of beer,
have your beer distributor fill the CO
2
cylinder. You must read and
understand the following procedures for CO
2
cylinders before installation:
1) Put the beer tower directly over the hole at the top of the beer
dispenser’s upper surface. Fix the beer tower assembly with screws
directly on the upper surface of the beer dispenser. (See Figure 1)
Screw the tap handle clockwise to make a form connection. Then
connect the tap to the beer tower components and
tighten it with a wrench.
2) Attach the CO
2
regulator to the CO
2
cylinder by
screwing the regulator nut onto the cylinder valve and
tightening it with an adjustable wrench (not included)
3) Take out the accessories of the keg coupler
a. Fix the CO
2
hose clamp on the red
CO
2
tube.
b. Attach the red CO
2
pressure tube to
the CO
2
regulator’s outlet nipple and connect
the other end of the tube to the CO
2
pressure
inlet nipple on the keg coupler, secure both
ends with a clamp. (Figure 3)
c. Open the CO
2
valve by turning the knob counterclockwise. Open it all
the way to avoid any gas leaks. Then set the CO
2
pressure to 5psi. Tighten
the locknut on the pressure adjusting screw to prevent tampering with the
settings.
4) Place the CO
2
tank and CO
2
regulator into the cabinet and fix the CO
2
tank
with the tank bracket and retainer.
Installing the beer keg
1) Connect the transparent beer line to the keg coupler and tighten it, the keg
coupler’s handle should be facing up, indicating that the keg is untapped (Figure 2).
2) Place the keg coupler onto the key and lock it into the lugs with a one-quarter clockwise turn.
3) Pull the handle out and push down, this
will tap the keg.
4) Turn the shut-off lever down to allow the
gas to flow.
Loading ...
Loading ...
Loading ...