Loading ...
Loading ...
Loading ...
10
Installing the tap handle and beer tap
Screw the tap handle clockwise into the beer tap and connect the tap to the beer tower components
and tighten it with a wrench.
Installing the Upper Cover Guardrail and Drip Tray
Set the upper cover guardrail and drip tray on top of the beer dispenser.
Notes:
•
When replacing the beer keg, first turn off the safety switch on the CO
2
regulator
valve and
remove the mixed ball valve to take out the keg.
•
When replacing the CO
2
gas cylinder, remember to turn off the main switch of the CO
2
gas
cylinder and the safety switch on the CO
2
regulator valve. Afterward, use a wrench to loosen
the hexagonal nut port connecting the CO
2
regulator valve with the CO
2
tank. Then, using a
wrench, remove the fixed bolt of the CO
2
tank to take out the CO
2
tank.
•
During the installation process, be sure that all parts are connected tightly and that there are no
gas leaks.
•
When connecting the hose to the connection port, you can dip the ends into warm water to
make the connection easier.
•
If the high-pressure compressed gas in the CO
2
tank is not handled properly, it
could be
dangerous:
o
Make a note of the D.O.T. testing date on the cylinder neck before installation. If it is more
than 5 years old, don’t use the product. Return it to the gas supplier.
o
Keep gas cylinder away from heat sources. Unused cylinders should be placed upright in a
cool, ventilated place (preferably at 70ᵒF).
NOTE: TEST FOR CO
2
LEAKS AFTER EACH FITTING, WITH A
MIXTURE OF SOAP AND WATER
Loading ...
Loading ...
Loading ...