Loading ...
Loading ...
Loading ...
188
Appendix
SettingsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Tips
Symptom Cause/Solution Page
DTS sound is not output. •Check that the digital audio output setting on the connected device is set to “DTS”.
•Set “Decode Mode” on the menu to “Auto” or “DTS”.
–
152
Dolby TrueHD, DTS-HD, Dolby Digital
Plus audio is not output.
•Make HDMI connections.
•Check the digital audio output setting on the connected device. On some devices, “PCM” is
set by default.
34,35
–
Dolby PLg mode or DTS NEO:X mode
cannot be selected.
•It cannot be selected when “None” is set for “Speaker Config.” – “Center” and “Surround”.
•These cannot be selected when using the headphones.
163
–
Audyssey MultEQ® XT, Audyssey
Dynamic EQ® and Audyssey Dynamic
Volume® cannot be selected.
•These cannot be selected when you have not performed Audyssey® Setup.
•Switch the sound mode to other than “DIRECT” or “PURE DIRECT”.
•These cannot be selected when using the headphones.
•These cannot be selected when an HD audio format with a sampling frequency of over 96 kHz
is input (such as may be found on select Dolby TrueHD and DTS-HD discs).
153
103
–
–
Audyssey DSX® cannot be selected. •It can be selected when using the front height or front wide speakers.
•It can be selected when using the center speaker.
•Switch the sound mode to DOLBY sound mode or DTS sound mode.
•This cannot be selected when using the headphones.
•This cannot be selected when an HD audio format with a sampling frequency of over 96 kHz
is input (such as may be found on select Dolby TrueHD and DTS-HD discs).
164
163
102
–
–
“Restorer” cannot be selected. •Check that an analog signal or PCM signal (Sample Rate=44.1/48 kHz) is input. For playback
of multichannel signals such as Dolby Digital or DTS surround, “Restorer” cannot be used.
•Switch the sound mode to other than “DIRECT” or “PURE DIRECT”.
137
103
Loading ...
Loading ...
Loading ...