Loading ...
Loading ...
Loading ...
4. Close the door.
5. Press the POWER button.
6. Select a timed drying cycle and temperature (see following chart). Items containing foam,
rubber or plastic must be dried on a clothesline or by using the Air Fluff temperature
setting.
7. You must select a time by pressing T]MED CYCI.E ADJUST Up or Down. Reset time as
needed to complete drying. Refer to the following table.
8. Press (and hold) START button (about 1 second).
[his chart shows examples of items that can be rack dried and the suggested cycle,
temperature setting and drying time. Actual drying time will depend on the amount of
moisture items hold.
Rack Dry Setting Temp. Time*
Wool Sweaters Timed Dry Low 60
Block to shape and lay flat on the rack.
Stuffed toys or pillows Timed Dry low 60
Cotton or polyester fiber filled
Stuffed toys or pillows Timed Dry Air Fluff (no 90
Foam rubber filled heat)
Sneakers or canvas shoes Timed Dry Air Fluff (no 90
he at )
*(Minutes) Reset time to complete drying, if needed.
DRYER CARE
CLEANING THE DRYER LOCATION
Keep dryer area clear and free from items that would obstruct the flow of combustion and
ventilation air.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation,
Failure to do so can result in death, explosion, or fire.
CLEANING THE LINT SCREEN
Clean the lint screen before each load. A screen blocked by lint can increase drying time.
IMPORTANT:
• Do not run the dryer with the lint screen loose, damaged, blocked or missing. E)oing so
can cause overheating and damage to both the dryer and fabrics.
• ]f lint falls off the screen into the dryer during removal, check the exhaust hood and
remove the lint.
Every load cleaning
1. The lint screen is located on the top of the dryer. Pull the lint screen toward you. Roll lint
off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is
hard to remove.
2. Push the lint screen firmly back into place.
As needed cleaning
1. Roll lint off screen with your fingers.
2. Wet both sides of lint screen with hot water.
3. Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to
remove residue buildup.
4. Rinse screen with hot water.
5. Thoroughly dry lint screen with a clean towel. Insert lint screen back into dryer.
Loading ...
Loading ...
Loading ...