Loading ...
Loading ...
Loading ...
TO ASSEMBLE THE HANDLE NOTE: Make sure the cables are not
1. Cut tie holding shift rod to lower han- caught between the upper and lower han-
dle and move shifter to the neutral die.
position. 4. Raise the upper handle into operating
2. Loosen, but do not remove, the position.
screws, flatwashers, Iockwashers,
and hex nuts in the upper holes of the NOTE: Ifthe cables have become dis-
lower handle. See Figure 3. connected form the drive levers, reinstall
3. Remove the fasteners from the lower the cables as shown in Figure 4.
holes of the lower handle See
Figure 3.
Lever
Hand Side "Z" Fitting
\
5/
5/16" Split _"
Lockwasher
Loosen,
but do not
remove
11/32"
Flatwesher
5/16"
Screw
Figure 3
Control Cable Figure 4
5. Install the fasteners that were re-
moved in step 3. DO NOT tighten until
all bolts are in place.
6. Tighten all handle bolts.
F-O31068L 8
Loading ...
Loading ...
Loading ...